Swap it out
The new angled base for the Hardness Tester is angled backward for a more ergonomic and comfortable experience.
Looking to upgrade your Hardness Tester with the angled base?
Doing so is as easy as 1-2-3.
1 – loosen and remove the screws on the underside of your Hardness Tester
2 – remove the flat base and replace it with the angled base
3 – insert and tighten the screws from the underside of the angled base
Remember to also reattach the Arbour of your Hardness Tester to the angled base, and then you are ready to continue hardness testing in style and comfort.
Note: this item only includes the base and not the entire Hardness Tester.
- Manufacturer
- Reeds 'n Stuff
- Product number
- 2200-000542200-00054
No review available for this product.