-
-
-
The lasered line helps to align the center of the gouge to the center of the shape.
-
-
-
-
The adjustable length stop enables simple centering of the cane lengthwise.
We have provided helpful orientation lines for 118 mm and 120 mm length cane positions.
-
Figure Machine
pending
Safety Precautions
Read the entire user manual before using this machine. The provided instructions are to be followed while using this machine.
This machine is only to be used by trained persons.
This machine is only to be used by one person at a time!
Workplace safety measures are to be observed, including: wearing sturdy shoes, not wearing clothing that is loose hanging, head covering (i.e. hairnet), and cut-resistant gloves.
This machine is only intended to cut cane. Attempting to process other materials violates the guarantee agreement.
DO NOT insert any body parts between the two upper plates!
DO NOT place any body parts between the Cutting Stamp and the Stencil!
General Comments
We recommend covering your work surface with a non-slip mat.
Be sure to unfold the support extensions before using the machine. This will provide leverage when depressing the lever.
This machine is intended to cut cane for bassoon and contrabassoon to shape. Bassoon Cane up to a length of 130 mm can be processed on the same machine, as there is an adjustable length stop.
Centering the Cane
Before shaping the cane, mark the center (or thickest point) of your gouge on the cane. We recommend doing this while the cane is in the gouging machine bed, as the arm of the cane holders can be used as a guide to find the center of the gouge.
There are two features of this machine designed to help you center the cane on the shape.
Using the Shaping Machine
Unfold the support extensions and insert the lever handle.
Check that the Cutting Stamp and Stencil are free of debris before continuing on to the next steps.
-
-
-
Place the cane with the bark facing down onto the shaping machine, pressed against the length stop and lined up with the center line.
-
-
-
-
Grab the handle and press down. Ensure that nothing but the piece of cane is under the shaping stamp.
-
-
-
-
Be sure to press the handle all the way down. This will ensure a clean separation of the shaped piece from the leftovers.
-
-
-
-
The shaped piece of cane will fall out of the bottom of the machine. It can be removed from below the base without your hands coming in contact with the sharp edges of the shaping stamp.
-
After this the leftover pieces of cane can be removed with a brush and the next piece placed in the machine.
Changing Shapes
Removing the Shape
Check that the cutting stamp and stencil are free of debris. Unscrew and remove the length stop.
Lower the cutting stamp into the stencil, loosen the screws and pins, then remove the pairing from the machine.
Be sure to keep the pair together. This is easily done with a piece of painters tape
Installing the New Shape
Check that the cutting stamp and stencil are free of debris. Beware of sharp edges.
Ensure that the cutting stamp is inside the stencil before attaching anything. Lay the parts onto the base, then insert and tighten the screws and pins.
Attach the length stop, set it to the desired length, and tighten the screw.
Transporting your Shaping Machine
Always carry the machine with two hands and only hold by the base.
DO NOT carry the machine by the lever.
Safety Instructions
Please always be careful while using your Reeds 'n Stuff product. The blades used in our machines, and reed making in general, are very sharp and may cause injuries and other damage.
In order to avoid negative consequences, you should follow the following safety instructions during installation, usage and maintenance of your machine:
Reeds 'n Stuff products are not a toys. They are therefore not to be used by children and persons with limited physical, sensory or mental abilities.
Reeds 'n Stuff products are intended to be used indoors.