Control and Quality
Precision, durability and reliability characterize Reeds 'n Stuff measuring devices.
The measuring device allows you to check the thickness and the symmetry of the reed at any given point.
The side plates on the left and right side can be adjusted in increments of 1 mm.
The reed tip plate works in the same manner.
Equipped with scale and positioning pins you can set it in 2 mm steps.
You can get our hardness testers analog or digital.
The precision of both devices is the same, they only differ in the convenience of the reading.
For Clarinet and Saxophone reeds.
The easiest way is to turn the dial so that the large pointer is back at ZERO. However, the dial indicator can also be recalibrated so that the large pointer is back at 12 o'clock. To do this, loosen the fastening screw that fixes the dial indicator in the dial indicator arm. Now position the dial indicator by moving it up or down so that both the small and large pointer show ZERO. When locking the screw do not tighten it too much, as this can block the axle movement in the dial indicator.
- Precision
- 1/100 mm
- Manufacturer
- Reeds 'n Stuff
- Country of origin
- Germany
- Product number
- F31-15000F31-15000
Contact
Reeds 'n Stuff GmbH
Karlsbader Straße 88c
09465 Sehmatal-Cranzahl
Germany
info@reedsnstuff.com
with limited physical, sensory or mental abilities.
There is a risk of injury if used improperly.
This product is intended to be used indoors.