-
-
To rotate the blade, first loosen the screw on the underside of the blade holder with the attached screwdriver.
-
-
Carefully rotate the blade to the next desired position.
-
-
Hold the blade in place while tightening the screw with the provided screwdriver and you are ready to profile.
A Revolution into the Future
After years of development, Reeds 'n Stuff is proud to offer the Blade 360°. When the blade becomes dull simply rotate to the next sharp section and continue profiling. This can be done at least 6 times, providing reeds and reeds of profiling before a replacement blade is needed.
The screw holding the blade is easily accessed from the underside, meaning once the height of the blade holder is set, you can set it and forget it. Simply loosen the screw, rotate the blade, and re-tighten the screw. Within seconds you can continue profiling reeds, rather than having to replace the entire blade.
Note: be sure not to over-tighten the screw holding the blade. Due to its small size it is possible to damage the screw and/or screwdriver in this manner.
FAQ 360° Blade
The Blade 360° can be used in at least 6 positions. Those who are very careful and precise could potentially use smaller rotations and therefore more positions.
You only need to purchase the blade holder once. After this only new spare blades need be be purchased, as the holder can be reused.
The Blade 360° with blade holder is delivered with several extra screws and the necessary screwdriver to adjust, rotate, and replace the blades. It is also possible to purchase a service set that includes extra screws and a replacement screwdriver.
The Blade 360° is designed to replace the current blade for the oboe profiling and bassoon tip profiling machines. If your oboe profiling or bassoon tip profiling machine has a curved blade, then the Blade 360° will fit on your machine.
- Manufacturer
- Reeds 'n Stuff
- Country of origin
- Germany
- Product number
- 1103-000241103-00024
Reeds ‘n Stuff produces reed making machines and a wide range of accessories for woodwind instruments. Founded in 1997 by Udo Heng in the beautiful Ore Mountains, the company has continued to develop ever since. Today, Reeds ‘n Stuff offers a wide range of useful, innovative and sustainable products that make reed making and the care of woodwind instruments easier.
Contact
Reeds 'n Stuff GmbH
Karlsbader Straße 88c
09465 Sehmatal-Cranzahl
Germany
info@reedsnstuff.com
with limited physical, sensory or mental abilities.
There is a risk of injury if used improperly.
This product is intended to be used indoors.
No review available for this product.