小さくて便利
今までは小さくて軽いのが特徴であった人気商品のミニ・キャリパーを改良しました!
台座の角度が自由自在に変えられる構造に進化しまして、一番見やすい角度に合わせられる様になりました
しかも、運搬の時には台座を真っ直ぐに出来て、普段持ち歩くリード工具入れに収納しやすくなりました。
キャリパー自体も回転させる事が出来て、右利き・左利きに設定出来ます。
先端部分をお選び下さい
先端部分 S, F, D は様々な角度から一つのポイントを計測するのに適しています。
球状になっている先端部分 K はリードやケーンをスライドさせても、
傷つける危険性がありません。
The easiest way is to turn the dial so that the large pointer is back at ZERO. However, the dial indicator can also be recalibrated so that the large pointer is back at 12 o'clock. To do this, loosen the fastening screw that fixes the dial indicator in the dial indicator arm. Now position the dial indicator by moving it up or down so that both the small and large pointer show ZERO. When locking the screw do not tighten it too much, this can block the axle movement in the dial indicator.
Can I change the tip of the dial indicator?Replacing the tip of the dial indicator is easy to do. You can simply turn out the tip that you have now with the help of pliers and replace it with the desired new tip. If there is not enough space between the tongue and the tip, you can loosen the screw that fixes the dial gauge in the dial gauge arm and remove the dial gauge from the arm. It may now be necessary to recalibrate the dial indicator.
Can I change the tongue of the dial indicator?The tongue of the dial gauge can also be changed very easily. You can find instructions here.
Can the hardness tester be used as a dial indicator?The support plate of the hardness tester is too large to obtain precise results. The thickness of finished reeds, for example, cannot be measured with the hardness tester. Inaccurate measurement results may occur also with gouged cane. For this reasons we do not recommend using the hardness tester as a dial indicator.
Can I transform my dial indicator from right to left-handed or do I need to buy a new one?The dial indicator can easily be transformed from right to left-handed. Simply loosen the set screw at the end of the arm holding the dial. This will allow you to rotate the dial to face the opposite direction. Be sure to calibrate the height of the dial so it both touches the tongue and reads "0" before tightening the set screw. Make sure not over-tighten this screw as it will damage the actuating shaft and prevent the dial from operating properly.
- Tongue width at the tip
- 3 mm
- 重量
- 145 g
- Tongue Length
- 21.80 mm
- 注
- 精度 1/100 mm
- メーカー
- Reeds 'n Stuff
お問い合わせ
Reeds 'n Stuff GmbH
Karlsbader Straße 88c
09465 Sehmatal-Cranzahl
Germany
info@reedsnstuff.com
誤った使い方をすると、怪我をする恐れがあります。
本製品は密室での使用を目的としています。